Task list. This will be updated regularly.

Front Relay box

Will be mounted

Need to:

Create circuit diagram 

Create the BMS circuit connections diagram

Bus bars need to be reconfigured to fit. 

Plexiglas need to be cut to make box.

Rear Battery boxes

Will be mounted to the frame

Need to:

Create circuit diagram 

Create the BMS circuit connections diagram

Bus bars need to be reconfigured to fit. 

Lower battery frame needs to be cut to fit the box width.

Front Battery boxes

Will be mounted to the Z-bar

Need to:

Create circuit diagram 

Create the BMS circuit connections diagram

Bus bars have been reconfigured to fit. 

Top rails need to be cut and bolted down.

Water cooling pump

Will be mounted to the bottom of the I-beam

Need to:

Create circuit diagram 

Create hydraulic diagram

Create control program

Need to order:

Square U-bolts

Mounting plate 

Mounting bolts 

ø25mm id hose to/from pump 

Regulator switch 

Relay (check supply)

Reservoir tank (have) 

Vacuum Pump

Will be mounted to the front of the I-beam

Need to:

Create circuit diagram

Create Pneumatic diagram 

Create control program

Need to order:

Square U-bolts

Mounting plate 

Mounting bolts 

3/8 hose from pump, what to booster check valve?

Regulator switch, Looking for MAP sensor with CAN output

Relay (check supply)

Reservoir tank (check supply) 

Check valve (check car)

Steering pump

Will be mounted at a much later date after the car is operational.

Will be mounted to the top of the I-beam on the passenger side between the windshield wiper fluid reservoir and the DMOC.

CAN codes have been found and are on a page specific to the pump.

Will require new hoses and fitting to be made.

Reservoir is built in and part of the return loop. 

Need to:

Create circuit diagram 

Create hydraulic diagram

Create control program

A/C compressor

Will be mounted at a much later date after the car is operational.

Will be mounted under the I-Beam on the drivers side.

Will require new hoses and fitting to be made.

Will require finding the CAN codes

Need to:

Create circuit diagram 

Create hydraulic diagram

Create control program